Williams Sound WIR TX8 Guía de instalación descargar pdf (Pagina 11)

IF YOU ARE USING MORE THAN ONE EMITTER:

Step 1: Determine the length of coaxial cable needed to reach between the emitters. 100 feet (30 m)

of coaxial cable is included with each emitter. You will need to cut it to length.

Additional RG–58 coax can be added. Make sure you leave some slack at each end.

Step 2: Install BNC connectors on each end of the cable. (See instructions on page 12.)

Step 3: Connect the baseband cable from the Baseband Out Jack on the first emitter in the chain

to the Baseband In jack on the next TX8 Emitter in the chain. Use the cable clamps and

screws provided to secure the cable. The coax can also be routed through conduit before

attaching BNC connectors. You can chain as many emitters together as you need.

Remember that each emitter needs its own TFP 010 power supply.

Baseband Out

TX10 Transmitter

Audio In

Baseband Out

Baseband In

To Additional

TX8 Emitters

Line Level Output

Power Supply

120 VAC (US): TFP 010

230 VAC (CE): TFP 027

TX8 Emitter

Power Supply

120 VAC (US): TFP 010

230 VAC (CE): TFP 027

Audio Source

Phones

Amplifier

Power

Compress

Audio

Compress

Audio

Level Level Level Level

FIGURE 8: TX8 EMITTER WIRING DETAIL

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Sin comentarios

Williams Sound WIR TX8 Guía de instalación Pagina 11