Williams Sound MOD 112 Guía de instalación descargar pdf (Pagina 19)

Williams Sound

Helping People Hear

RECEIVER

INSTRUCTIONS

IR RECEIVER MODELS WIR RX7 & WIR RX8

Make sure the “eye” on the front of the receiver is not covered up when in use. The receiver

is intended to be worn on the front of the body, hanging from the lanyard attached to the

receiver. The receiver will not work if it is placed in a pocket or purse. A variety of

earphones, headphones, or neckloop telecoil couplers can be used with both RX7 and RX8

Receivers.

Step 1: To install the batteries, open the battery compartment using a coin in the slot in the

bottom of the receiver. Press two AA batteries into place, observing proper battery

polarity.

Step 2: Plug the earphone or headphone into the earphone jack.

Step 3: Turn the receiver on by rotating the volume control knob clockwise.

Step 4: Adjust the tone to your preference using the slide switch tone control. To avoid

draining the battery, make sure the receiver is turned off when not in use.

BATTERY INFORMATION

For RX7 and RX8 Receivers in normal use, two AA alkaline batteries (BAT 001) will last

about 30 hours. Rechargeable AA batteries (BAT 026) will last about 15 hours per charge.

If you are using BAT 026 rechargeable batteries, use the CHG 200A Multi-Charger. Contact

your dealer or Williams Sound for details.

If the sound becomes weak or distorted, replace the batteries. The indicator light may still be

on, even with weak batteries. Do not leave dead batteries in the receiver, they may leak and

damage the receiver.

!! IMPORTANT WARNINGS !!

DO NOT ATTEMPT TO RECHARGE ZINC CARBON (“HEAVY DUTY”), ALKALINE, OR

LITHIUM BATTERIES!

DO NOT ATTEMPT TO RECHARGE SINGLE-USE BATTERIES!

These batteries may heat up

and explode, causing possible injury and damage to the equipment.

Avoid shorting the plus and minus battery terminals together with metal objects. Battery

damage and burns can result!

Use only Williams Sound supplied chargers and batteries!

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Sin comentarios

Williams Sound MOD 112 Guía de instalación Pagina 19