Williams Sound SoundPlus Infrared System WIR SYS 90V Guía de instalación descargar pdf (Pagina 4)

SoundPlus

Infrared Listening System

MAN 132H

MOD 232 Modulator Setup

Determine Location

The modulator is usually located with the sound system amplier or mixer for easy access to an audio input signal.

For portable systems, the modulator can be placed near the emitter or in another convenient location. Infrared Stand

Kit SS-6 is available for portable systems.

Wiring and Connections

Figure 1: MOD 232 (Rear View)

POWER

SUPPLY

A253

A255

INPUT CH A CH B

ACCEPTS ANY LOW

IMPEDANCE MICROPHONE

OR LINE LEVEL SIGNAL.

BASEBAND OUTPUT

SENDS INDIVIDUAL

AND/OR COMBINED

CARRIER FREQUENCIES

OF 2.3, 2.8, 3.3, 3.8 MHz

TO A TX9 EMITTER.

AUDIO LINE OUTPUT

RCA JACK FOR MONITORING,

RECORDING, OR ROUTING

PROCESSED AUDIO TO

ANOTHER SOUND SYSTEM.

POWER IN

24 VAC, 50-60Hz

120 VAC (US); TFP 016 POWER SUPPLY

230 VAC (CE); TFP 027 POWER SUPPLY

CONFIGURATION SWITCHES

CONTROLS CHANNEL SELECTION,

COMPRESSOR GAIN, MIC/LINE

INPUT, CHANNEL ON/OFF, AND

OTHER CONTROLS.

BASEBAND INPUT

A SECOND MODULATOR

MAY BE CONNECTED

HERE FOR 4 (FOUR)

CHANNEL OPERATION.

Figure 2: Power Connection

WARNING: POWERLINE VOLTAGE MUST NOT FALL BELOW 94V, OR SYSTEM

PERFORMANCE WILL BE GREATLY REDUCED!

Power Connection for U.S. Application

1. Connect the TFP 016 power supply to the 3-pin Molex connector located on the

rear of the MOD 232. (See Figure 2, right.)

For Applications Outside The U.S. Requiring 240 VAC Mains Supply:

Use the transformer power supply, model TFP 027.

Secondary specications: 24 VAC, 35 VA, 50/60 Hz.

2. Plug the power supply into the AC outlet.

1 2 3 4 5 6 7 8 9 ... 19 20

Comentarios a estos manuales

Sin comentarios

Williams Sound SoundPlus Infrared System WIR SYS 90V Guía de instalación Pagina 4

Comentarios a estos manuales

Relacionado con productos y manuales para Receptor Williams Sound SoundPlus Infrared System WIR SYS 90V