Williams Sound PPA R7 Guía de instalación Pagina 7
- Pagina / 20
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Williams Sound
®
Helping People Hear
SYSTEM SET-UP AND INSTALLATION
STEP 1: INSTALL THE ANTENNA
The “rubber duckie” whip antenna fits into the hole on top of the transmitter and threads onto
a mounting stud inside. Guide the antenna onto the stud and turn it clockwise to tighten. Do
not use excessive force to tighten the antenna. It only needs to be “finger-tight.”
ST
EP
2: CO
NNECT THE TRANSMITTER TO POWER
The T17 is supplied with a wall transformer power supply. Plug the transformer into a 120 V,
60 Hz wall outlet. Then plug the power cord into the “Power” connector on the rear panel of
the T17. The green indicator light on the front panel of the T17 should glow when the power
is connected.
There is no on/off switch. The T17 is designed to be continuously on. The wall
transformer can be plugged into a switched outlet that turns on when the other sound
equipment is turned on. If turning the T17 on creates a hum or buzz in the sound system, see
the Troubleshooting section on page 12.
STEP 3: MAKE AUDIO CONNECTIONS
3A: (IF YOU WILL BE USING THE T17 WITH ITS OWN MICROPHONE AS A STAND-ALONE SYSTEM)
Any Williams Sound microphone with a 3.5 mm mini phone plug can be used with the T17.
Plug the microphone into the “Mic” jack on the front panel of the T17.
The T17 is designed to supply positive DC voltage to the plug tip of 2-wire, “barefoot”
electret (power condenser) microphones. If you will be using the T17 with a non-Williams
Sound, Lo-Z (dynamic) microphone, this DC power should be turned off. (See page 8.) If
you use both the Microphone input and the Audio Input on the T17, the signals will be mixed
together.
3B: (IF YOU WILL BE USING THE T17 WITH AN EXISTING SOUND SYSTEM)
Refer to the figure 1 on page 4. Use the audio cable supplied to connect the T17 “Audio In”
jack to an appropriate audio output jack on the sound system mixer or amplifier. The T17 is
designed to work with an unbalanced, line-level audio signal. Suitable connections are:
Choice 1:
TAPE OUT or LINE OUT Jack
Choice 2: BOOSTER or BRIDGING Jack
Choice 3: Speaker Terminal, 8 Ohm Tap
If your amplifier or mixer does not have RCA-type connectors, you can obtain adapters from
your Williams Sound Authorized Dealer or a local radio parts store. If the TAPE OUT jack is
already in use, a Y-Cord can be used to connect the T17 and a second device to the same
jack.
STEP 4: TEST THE SYSTEM
Use a receiver to test the system and set the input level control. See the section, Receiver Use
Instructions
.
7
- Installation 1
- Guide & 1
- SYSTEM OVERVIEW 4
- SYSTEM CONTROLS AND FEATURES 6
- YSTEM SET-UP AND INSTALLATION 7
- RECEIVER USE INSTRUCTIONS 9
- Williams Sound 10
- BATTERY INFORMATION 11
- TROUBLE SHOOTING GUIDE 12
- FREQUENCY CHANGE INSTRUCTIONS 14
- 12345678 15
- R30 R- 31 R-32 16
- R7Y R7- 4 R7- 6 16
- WARRANTY 18
- PERSONAL PA 19
- Williams Sound Corp 20
Relacionado con productos y manuales para Receptor Williams Sound PPA R7
Receptor Williams Sound PPA VP 37 Guía de usuario
(24 paginas)
(24 paginas)
Receptor Williams Sound TGS 300 Manual de usuario
(19 paginas)
(19 paginas)
Receptor Williams Sound PPA T36 Guía de usuario
(16 paginas)
(16 paginas)
Receptor Williams Sound PPA R37 Guía de usuario
(32 paginas)
(32 paginas)
Receptor Williams Sound Wireless, Portable FM Listening System TGS 173 Manual de usuario
(20 paginas)
(20 paginas)
Receptor Williams Sound WIR RX5 Especificaciones
(4 paginas)
(4 paginas)
Receptor Williams Sound WIR TX8 Especificaciones
(4 paginas)
(4 paginas)
Receptor Williams Sound DLR 60 2.0 Manual de usuario
(32 paginas)
(32 paginas)
Receptor Williams Sound WIR RX6 Guía de instalación
(24 paginas)
(24 paginas)
Receptor Williams Sound TGS 300 Guía de usuario
(20 paginas)
(20 paginas)
Receptor Williams Sound MOD 112 Guía de instalación
(24 paginas)
(24 paginas)
Sharp MX-2615N manuály
Uživatelské manuály a uživatelské příručky pro Kopírky Sharp MX-2615N.
Poskytujeme 1 manuály pdf Sharp MX-2615N ke stažení zdarma podle typů dokumentů: Brožura
Comentarios a estos manuales